Furnace Repair and Installation in Afton, Texas

The most common causes are a cracked hot surface igniter, a dirty flame sensor, a blocked pressure switch hose, or a failed inducer motor. Modern furnaces store fault codes that point directly at the failure, which is where our technicians start.

It means the furnace heats up too fast, hits the high limit, and shuts off before satisfying the thermostat. It is nearly always an airflow restriction. Fixing the limit switch without correcting airflow just delays the next failure.

Yes. A cracked exchanger can allow combustion gases into the supply air. If we find one in a Afton home we will show you the evidence and recommend shutting the furnace down until it is replaced.

Fifteen to twenty years is typical in Afton, since Texas furnaces run relatively few hours compared with the air conditioning side. Neglected units and units in hot attics tend to fall at the lower end of that range.

Yes, along with dual-fuel systems that pair a heat pump with a gas furnace. Each type has a different failure profile and our technicians carry the common parts for all of them.

A fall check is worth it in Afton mainly for the combustion and safety inspection. It also catches the airflow and ignition problems that turn into a no-heat call on the first freezing night.

That is almost always a distribution problem: an undersized or disconnected duct run, a closed damper, poor return air, or attic heat gain on a long duct. It is fixable, and it usually does not require new equipment. Our HVAC repair team in Afton measures airflow to find the cause.

There is a diagnostic fee for the trip and the testing, and you are told the exact amount before we schedule. Once you know what is wrong, the repair is quoted at a flat price you approve before any work begins. Nothing gets added to the invoice that you did not agree to.