Furnace Repair and Installation in Carrizo Springs, Texas

The most common causes are a cracked hot surface igniter, a dirty flame sensor, a blocked pressure switch hose, or a failed inducer motor. Modern furnaces store fault codes that point directly at the failure, which is where our technicians start.

It means the furnace heats up too fast, hits the high limit, and shuts off before satisfying the thermostat. It is nearly always an airflow restriction. Fixing the limit switch without correcting airflow just delays the next failure.

Yes. A cracked exchanger can allow combustion gases into the supply air. If we find one in a Carrizo Springs home we will show you the evidence and recommend shutting the furnace down until it is replaced.

Fifteen to twenty years is typical in Carrizo Springs, since Texas furnaces run relatively few hours compared with the air conditioning side. Neglected units and units in hot attics tend to fall at the lower end of that range.

Yes, along with dual-fuel systems that pair a heat pump with a gas furnace. Each type has a different failure profile and our technicians carry the common parts for all of them.

A fall check is worth it in Carrizo Springs mainly for the combustion and safety inspection. It also catches the airflow and ignition problems that turn into a no-heat call on the first freezing night.

Yes, including inverter board faults and communication errors that many general HVAC companies avoid. Mini splits are covered under our heat pump and mini split service in Carrizo Springs.

The usual rule of thumb is that if the repair costs more than a third of a new system and the unit is past ten to twelve years old, replacement is the better value. But there are exceptions in both directions. We give you the repair price and the replacement price side by side and let you decide without pressure. See our AC installation options in Carrizo Springs.