Furnace Repair and Installation in Cibolo, Texas

The most common causes are a cracked hot surface igniter, a dirty flame sensor, a blocked pressure switch hose, or a failed inducer motor. Modern furnaces store fault codes that point directly at the failure, which is where our technicians start.

It means the furnace heats up too fast, hits the high limit, and shuts off before satisfying the thermostat. It is nearly always an airflow restriction. Fixing the limit switch without correcting airflow just delays the next failure.

Yes. A cracked exchanger can allow combustion gases into the supply air. If we find one in a Cibolo home we will show you the evidence and recommend shutting the furnace down until it is replaced.

Fifteen to twenty years is typical in Cibolo, since Texas furnaces run relatively few hours compared with the air conditioning side. Neglected units and units in hot attics tend to fall at the lower end of that range.

Yes, along with dual-fuel systems that pair a heat pump with a gas furnace. Each type has a different failure profile and our technicians carry the common parts for all of them.

A fall check is worth it in Cibolo mainly for the combustion and safety inspection. It also catches the airflow and ignition problems that turn into a no-heat call on the first freezing night.

Most standard appointments in Cibolo are scheduled same day or next day, and emergency calls are dispatched as soon as a technician is free. When you call (833) 435-6611 the dispatcher will give you a realistic arrival window rather than an optimistic one, and you will get a call ahead before the technician arrives.

Yes. We run seven days a week, including holidays, throughout Cibolo and the surrounding Texas communities. Emergency and after-hours calls are quoted before work starts so there is no bill shock later.