Heater Repair in Maud, TX

On a gas system, the blower may be running while the burners fail to light, usually an igniter, flame sensor, or pressure switch issue. On a heat pump, cold air often means the system is stuck in cooling mode or the reversing valve has failed. On electric heat, failed sequencers or heat strips are common.

No-heat calls in Maud are prioritized during cold weather and we run 24 hours. Call (833) 435-6611 and describe your situation so dispatch can rank the urgency properly.

A faint dusty smell the first time you run heat each season is normal and clears within an hour. A persistent burning, plastic, or electrical smell is not. Shut the system down at the breaker and call for service.

Short cycling usually means the system is overheating and tripping the high limit, caused by restricted airflow. A dirty filter, closed vents, or a crushed duct is the typical culprit. An oversized system will short cycle too.

Yes. Failed heating elements, sequencers, and contactors are common on electric furnaces and heat pump auxiliary heat, and they are all serviceable rather than requiring full replacement.

Igniters, flame sensors, and thermostats are on the affordable end. Gas valves, inducer motors, and control boards cost more. Heat exchanger failures usually push toward replacement. You get the flat-rate price before work starts.

That is almost always a distribution problem: an undersized or disconnected duct run, a closed damper, poor return air, or attic heat gain on a long duct. It is fixable, and it usually does not require new equipment. Our HVAC repair team in Maud measures airflow to find the cause.

There is a diagnostic fee for the trip and the testing, and you are told the exact amount before we schedule. Once you know what is wrong, the repair is quoted at a flat price you approve before any work begins. Nothing gets added to the invoice that you did not agree to.